Wireless Personal Panic Device

Note: You will need a small Philips screwdriver (looks like an x).

1
one

Unscrew the bottom of the device.

2
two

Remove the bottom and the rubber wristband.

3
three

Gently remove the circuit board

4
four

Gently remove the battery from its connections. If this is difficult, you can use the edge of one of the rubber pieces that make up the wristband.

5
five

Note the battery terminals (+, -).

6
six

Place a new battery in the device (CR1632).

7
seven

Place the circuit board back in the plastic cover, ensuring the lights line up with the slots on the cover.

8
eight

Replace the rubber wristband pieces and the base of the device.

9
nine

Screw in the base.

10
ten

Test the device by pressing the button. A light will blink to signal the device is operational.